Power House

Assembly Guide

Main Body

USB Hub/Power Supply

USB Hub + Power Supply

Double-Sided Tape

Screw-On Feet

What's Included

What's Not Included

Flat-Head Screwdriver

Assembly Steps

Adhere the Double-Sided Tape to the USB Hub.

Press the USB Hub to the interior face of the Main Body.

Plug in each charging cradle into the USB Hub.

Note: The USB Hub needs to be oriented top-down with ports facing up.

Secure the Power Supply chord using the Cable Strain Relief Clamp as shown.

Note: Charging cradles may be plugged into the USB Hub in any order. Power is being supplied equally to each port.

Slide the Main Body onto the Back Plate and tighten the Screw-On Feet with a Flat-Head Screwdriver.

Optional: If mounting the Power House, attach the Back Plate to a suitable wall structure with appropriate hanging hardware before sliding on the Main Body.

Plug in and check to see that each cradle is receiving power (indicated by red LED light).

Finished!

Note: The Power House is designed for indoor use and installation only. Clean as needed with isopropyl alcohol wipes. Do not use bleach.

Recommendations for Planning a Wall-Mounted Power House Station

Vertical Spacing

No more than 5 Power Houses per column when arranged in a stack

Leave at minimum 10 inches between Power Houses (from bottom to bottom) for ease of viewing the display on Nymi Bands

The bottom-most Power House in a column should be at least 20 inches away from the floor

Horizontal Spacing

Leave at minimum 3 inches between Power Houses when arranged in a row for ease of cleaning

Power Source

The power source can be underneath the charging station area for easy access and all the wires will be out of the way